D-Link DES-3052P - Page 154

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
149
Each command is listed, in detail, in the following sections
enable 802.1x
Purpose Used to enable the 802.1X server on the Switch.
Syntax
enable 802.1x
Description The enable 802.1x command enables the 802.1X Network Access
control application on the Switch. To select between port-based or Host-
based, use the config 802.1x auth_mode command.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable 802.1X switch wide:
DES-3028P:4#enable 802.1x
Command: enable 802.1x
Success.
DES-3028P:4#
disable 802.1x
Purpose Used to disable the 802.1X server on the Switch.
Syntax
disable 802.1x
Description The disable 802.1x command is used to disable the 802.1X Network
Access control application on the Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To disable 802.1x on the Switch:
DES-3028P:4#disable 802.1x
Command: disable 802.1x
Success.
DES-3028P:4#