DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
150
show 802.1x auth_configuration
Purpose Used to display the current configuration of the 802.1X server on the
Switch.
Syntax
show 802.1x auth_configuration {ports <auth_portlist>}
Description The show 802.1x auth_configuration command is used to display the
802.1X Port-based or Host-based Network Access control local users
currently configured on the Switch.
Parameters
ports <auth_portlist> Specifies a port or range of ports to view.
The following details are displayed:
802.1x Enabled / Disabled Shows the current status of 802.1X
functions on the Switch.
Authentication Mode – Shows the authentication mode, whether it be
by MAC address or by port.
Authentication Protocol Shows the authentication protocol suite in
use between the Switch and a RADIUS server. May read Radius_Eap
or local.
Port number Shows the physical port number on the Switch.
Capability: Authenticator/None Shows the capability of 802.1X
functions on the port number displayed above. There are two 802.1X
capabilities that can be set on the Switch: Authenticator and None.
AdminCtlDir: Both / In Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
OpenCtlDir: Both / In Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
Port Control: ForceAuth / ForceUnauth / Auto Shows the
administrative control over the port’s authorization status. ForceAuth
forces the Authenticator of the port to become Authorized.
ForceUnauth forces the port to become Unauthorized.
QuietPeriod This is the initialization value of the quiet period timer.
The default value is 60s and can be any value between 0-65535.
TxPeriod This us the initialization value of the tx timer. The default
value is 30s and can be any value between 1-65535.
SuppTimeout Shows the time to wait for a response from a supplicant
(user) for all EAP packets, except for the Request / Identity packets.
ServerTimeout Shows the length of time to wait for a response from a
RADIUS server.
MaxReq Shows the maximum number of times to retry sending
packets to the supplicant.
ReAuthPeriod Shows the time interval between successive re-
authentications.
ReAuthenticate: Enabled / Disabled Shows whether or not to re-
authenticate.
Restrictions None.
Example usage:
To display the 802.1X authentication states:
To Next Page
Loading...
