D-Link DES-3052P - Page 214

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
209
config authen_login
same sequence with the following protocol listed, xtacacs. If no
authentication takes place using the xtacacs list, the local account
database set in the Switch is used to authenticate the user. When the
local method is used, the privilege level will be dependant on the local
account privilege configured on the Switch.
Successful login using any of these methods will give the user a “user”
privilege only. If the user wishes to upgrade his or her status to the
administrator level, the user must implement the enable admin
command, followed by a previously configured password. (See the
enable admin part of this section for more detailed information,
concerning the enable admin command.)
Parameters default – The default method list for access authentication, as defined
by the user. The user may choose one or a combination of up to four(4)
of the following authentication methods:
 tacacs – Adding this parameter will require the user to be
authenticated using the TACACS protocol from the remote
TACACS server hosts of the TACACS server group list.
 xtacacs – Adding this parameter will require the user to be
authenticated using the XTACACS protocol from the remote
XTACACS server hosts of the XTACACS server group list.
 tacacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from the remote
TACACS+ server hosts of the TACACS+ server group list.
 radius  Adding this parameter will require the user to be
authenticated using the RADIUS protocol from the remote
RADIUS server hosts of the RADIUS server group list.
 server_group <string 15>  Adding this parameter will require
the user to be authenticated using a user-defined server group
previously configured on the Switch.
 local  Adding this parameter will require the user to be
authenticated using the local user account database on the
Switch.
 none – Adding this parameter will require no authentication to
access the Switch.
method_list_name – Enter a previously implemented method list name
defined by the user. The user may add one, or a combination of up to
four (4) of the following authentication methods to this method list:
 tacacs – Adding this parameter will require the user to be
authenticated using the TACACS protocol from a remote
TACACS server.
 xtacacs – Adding this parameter will require the user to be
authenticated using the XTACACS protocol from a remote
XTACACS server.
 t
acacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from a remote
TACACS+ server.
 radius  Adding this parameter will require the user to be
authenticated using the RADIUS protocol from a remote
RADIUS server.
 server_group <string 15>  Adding this parameter will require
the user to be authenticated using a user-defined server group
previously configured on the Switch.
 local  Adding this parameter will require the user to be
authenticated using the local user account database on the
Switch.
 none – Adding this parameter will require no authentication to
access the Switch.