D-Link DES-3052P - Page 226

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
221
config authen server_group
Purpose Used to configure a user-defined authentication server group.
Syntax
config authen server_group [tacacs | xtacacs | tacacs+ | radius |
<string 15>] [add | delete] server_host <ipaddr> protocol [tacacs |
xtacacs | tacacs+ | radius]
Description This command will configure an authentication server group. A server
group is a technique used to group
TACACS/XTACACS/TACACS+/RADIUS server hosts into user defined
categories for authentication using method lists. The user may define the
type of server group by protocol or by previously defined server group. Up
to eight authentication server hosts may be added to any particular group
Parameters
server_group  The user may define the group by protocol groups built into
the Switch (TACACS/XTACACS/TACACS+/RADIUS), or by a user-defined
group previously created using the create authen server_group command.
 tacacs – Use this parameter to utilize the built-in TACACS server
protocol on the Switch. Only server hosts utilizing the TACACS
protocol may be added to this group.
 xtacacs – Use this parameter to utilize the built-in XTACACS
server protocol on the Switch. Only server hosts utilizing the
XTACACS protocol may be added to this group.
 tacacs+ – Use this parameter to utilize the built-in TACACS+
server protocol on the Switch. Only server hosts utilizing the
TACACS+ protocol may be added to this group.
 radius – Use this parameter to utilize the built-in RADIUS server
protocol on the Switch. Only server hosts utilizing the RADIUS
protocol may be added to this group.
 <string 15>  Enter an alphanumeric string of up to 15 characters
to define the previously created server group. This group may add
any combination of server hosts to it, regardless of protocol.
add/delete – Enter the correct parameter to add or delete a server host
from a server group.
server_host <ipaddr>  Enter the IP address of the previously configured
server host to add or delete.
protocol – Enter the protocol utilized by the server host. There are three
options:
 tacacs – Use this parameter to define the protocol if the server
host is using the TACACS authentication protocol.
 xtacacs – Use this parameter to define the protocol if the server
host is using the XTACACS authentication protocol.
 tacacs+ – Use this parameter to define the protocol if the server
host is using the TACACS+ authentication protocol.
 radius – Use this parameter to define the protocol if the server
host is using the RADIUS authentication protocol.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To add an authentication host to server group “group_1”:
DES-3028P:4# config authen server
_
group group
_
1 add
server_host 10.1.1.121 protocol tacacs+
Command: config authen server
_
group group
_
1 add
server_host 10.1.1.121 protocol tacacs+
Success.