DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
225
enable admin
authentication (none). Because XTACACS and TACACS do not
support the enable function, the user must create a special account on
the server host which has the username “enable”, and a password
configured by the administrator that will support the “enable” function.
This function becomes inoperable when the authentication policy is
disabled.
Parameters None.
Restrictions None.
Example usage:
To enable administrator privileges on the Switch:
DES-3028P:4#enable admin
Password: ******
DES-3028P:4#
config admin local_enable
Purpose Used to configure the local enable password for administrator level
privileges.
Syntax
config admin local_enable
Description This command will configure the locally enabled password for the
enable admin command. When a user chooses the “local_enable”
method to promote user level privileges to administrator privileges,
he or she will be prompted to enter the password configured here
that is set locally on the Switch.
Parameters
<password 15> After entering this command, the user will be
prompted to enter the old password, then a new password in an
alphanumeric string of no more than 15 characters, and finally
prompted to enter the new password again for confirmation. See the
example below.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the password for the “local_enable” authentication method.
DES-3028P:4#config admin local_enable
Command: config admin local_enable
Enter the old password:
Enter the case-sensitive new password:******
Enter the new password again for
confirmation:******
Success.
DES-3028P:4#
To Next Page
Loading...
