D-Link DES-3052P - Page 288

DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
283
Example usage:
To create IGMP snoop multicast VLAN mv12:
DES-3028P:4# create igmp_snoop multicast_vlan mv1 2
Command: create igmp_snoop multicast_vlan mv1 2
Success.
DES-3028P:4#
config igmp_snooping multicast_vlan
Purpose Used to configure the parameter of the specific multicast VLAN.
Syntax
config igmp_snooping multicast_vlan <vlan_name 32>
{[add|delete] [member_port <portlist>| tag_member_port
<portlist> | source_port <portlist>] | state [enable | disable] |
replace_source_ip [<ipaddr>|none]}
Description The config igmp_snooping multicast_vlan command allows you
to add a member port, add a tag member port, and add a source
port to the port list. The member port will automatically become the
untagged member of the multicast VLAN, the tag member port and
the source port will automatically become the tagged member of the
multicast VLAN. To change the port list, the new port list will replace
the previous port list if the add or delete is not specified.
The member port list and source port list can not overlap. However,
the member port of one multicast VLAN can overlap with another
multicast VLAN.
The multicast VLAN must be created first before configuration.
Parameters
<vlan_name>  The name of the VLAN to be created. Each multicast
VLAN is given a name that can be up to 32 characters.
member_port <portlist> – A range of member ports to add to the
multicast VLAN. They will become the untagged member port of the
ISM VLAN.
tag_member_port <portlist>  Specifies the tagged member port of
the ISM VLAN.
source_port  A range of source ports to add to the multicast VLAN.
state - enable or disable multicast VLAN for the chosen VLAN.
replace_source_ip  With the IGMP snooping function, the IGMP
report packet sent by the host will be forwarded to the source port.
Before the forwarding of the packet, the source IP address in the join
packet needs to replaced by this IP address. If none is specified the
source IP address will not be replaced.
none – Specifies that the source IP address will not be replaced.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure an IGMP snoop multicast VLAN:
DES-3028P:4# config igmp
_
snooping multicast
_
vlan v1 add member
_
port
1,3 state enable
Command: config igmp_snooping multicast_vlan v1 add member
_
port 1,3
state enable
Success.