DES-3028 DES-3028P DES-3028G DES-3052 DES-3052P Layer 2 Fast Ethernet Switch CLI Reference Manual
295
Example usage
To configure the delay-interval interval:
DES-3028P:4# config lldp tx_delay 8
Command: config lldp tx_delay 8
Success.
DES-3028P:4#
config lldp reinit_delay
Purpose Change the minimum time of reinitialization delay interval.
Syntax
config lldp reinit_delay < sec 1 – 10 >
Description An re-enabled LLDP port will wait for reinit_delay after last disable
command before reinitializing
Parameters
reinit_delay The range is from 1 second to 10 seconds. The default
setting 2 seconds.
Restrictions Only Administrator-level users can issue this command.
Example usage
To change the re-initialization delay interval:
DES-3028P:4# config lldp reinit_delay 5
Command: config lldp reinit_delay 5
Success.
DES-3028P:4#
config lldp notification_interval
Purpose Used to configure the timer of the notification interval used to send
notifications to configured SNMP trap receiver(s).
Syntax
config lldp notification_interval <sec 5 - 3600 >
Description Globally change the interval between successive LLDP change
notifications generated by the switch.
Parameters
notification_interval The range is from 5 second to 3600 seconds. The
default setting is 5 seconds.
Restrictions Only Administrator-level users can issue this command.
To Next Page
Loading...
