address
00-00-00-00-00-06
Command: delete address-binding ip-mac ipaddress 10.1.1.1 mac_address 00-
00-00-00-00-06
Success.
DES-3028P:4#
enable address_binding trap_log
Purpose Used to enable the trap log for the IP-MAC binding function.
Syntax
enable address_binding trap_log
Description This command, along with the disable address_binding trap_log
will enable and disable the sending of trap log messages for IP-MAC
binding. When enabled, the Switch will send a trap log message to
the SNMP agent and the Switch log when an ARP packet is received
that doesn’t match the IP-MAC binding configuration set on the
Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable sending of IP-MAC Binding trap log messages on the Switch:
DES-3028P:4#enable address_binding
trap_log
Command: enable address_binding trap_log
Success.
DES-3028P:4#
disable address_binding trap_log
Purpose Used to disable the trap log for the IP-MAC binding function.
Syntax
disable address_binding trap_log
Description This command, along with the enable address_binding trap_log
will enable and disable the sending of trap log messages for IP-MAC
binding. When enabled, the Switch will send a trap log message to
the SNMP agent and the Switch log when an ARP packet is received
that doesn’t match the IP-MAC binding configuration set on the
Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To disable sending of IP-MAC Binding trap log messages on the Switch:
To Next Page
Loading...
