D-Link DES-3326S - Commands

D-Link DES-3326S Layer 3 Switch CLI Reference
20
802.1X COMMANDS
The DES-3326S implements the server-side of the IEEE 802.1x Port-based and MAC-based Network Access
Control. This mechanism is intended to allow only authorized users, or other network devices, access to
network resources by establishing criteria for each port on the Switch that a user or network device must meet
before allowing that port to forward or receive frames.
Command Parameters
enable 802.1x
disable 802.1x
show 802.1x [auth_state | auth_configuration] {ports
<portlist>}
config 802.1x capability ports <portlist>|all
authenticator
none
config 802.1x auth_parameter ports <portlist>|all
default
direction [both|in]
port_control
[force_unauth|auto|force_auth]
quiet_period <sec 0-65535>
tx_period <sec 1-65535>
server_timeout <sec 1-65535>
enable_reauth [enable|disable]
supp_timeout <sec 1-65535>
max_req <value 1-10>
reauth_period <sec 1-65535>
config 802.1x auth_mode [port_based | mac_based]
config 802.1x auth_protocol [radius_eap | radius_pap]
config 802.1x init config 802.1x init [port_based ports
[<portlist|all>] |mac_based ports [<portlist>|all]
{mac_address <macaddr>}]
config 802.1x reauth [port_based ports [<portlist|all>] |mac_based
ports [<portlist>|all] {mac_address
<macaddr>}]
config radius add <server_index 1-3>
<server_ip>
default
auth_port <udp_port_number>
acct_port <udp_port_number>
key <passwd 32>
config radius delete <server_index 1-3>
160