D-Link DES-3326S - Basic Switch Commands

D-Link DES-3326S Layer 3 Switch CLI Reference
4
BASIC SWITCH COMMANDS
The basic Switch commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
create account [admin|user]
<username>
config account <username>
show account
show session
show switch
show serial_port
config serial_port baud_rate [9600|19200|38400|115200]
auto_logout [never|2_minutes|5_minutes
|10_minutes|15_minutes]
enable clipaging
disable clipaging
enable telnet <tcp_port_number>
disable telnet
enable web <tcp_port_number>
disable web
save
reboot
reset {config|system}
login
logout
Each command is listed, in detail, in the following sections.
12