D-Link DES-3326S Layer 3 Switch CLI Reference
28
IGMP COMMANDS
The IGMP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
config igmp ipif <ipif_name 12>
all
version <value 1-2>
query_interval <1-65535 sec>
max_response_time <1-25 sec>
robustness_variable <value 1-255>
last_member_query_interval <value 1-25>
state [enable|disable]
show igmp ipif <ipif_name 12>
show igmp group group <group>
ipif <ipif_name 12>
Each command is listed, in detail, in the following sections.
231
To Next Page
Loading...
