D-Link DES-3326S - Bootp Relay Commands

D-Link DES-3326S Layer 3 Switch CLI Reference
29
BOOTP RELAY COMMANDS
The BOOTP relay commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
hops <value>
time <sec>
config bootp_relay
add
ipif <ipif_name>
<ipaddr>
config bootp_relay
delete
ipif <ipif_name>
<ipaddr>
enable bootp_relay
disable bootp_relay
show bootp_relay
Parameters
config bootp_relay
ipif <ipif_name>
Each command is listed, in detail, in the following sections.
235