D-Link DES-3326S - RIP Commands

D-Link DES-3326S Layer 3 Switch CLI Reference
31
RIP COMMANDS
The RIP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
config rip ipif <ipif_name 12>
all
authentication [enable <password>|disable]
tx_mode <value 1-16>
[disable|v1_only|v1_compatible|v2_only]
rx_mode [v1_only|v2_only|v1_or_v2|disable]
state [enable|disable]
enable rip
disable rip
show rip ipif <ipif_name 12>
Each command is listed, in detail, in the following sections.
250