DES-3526 Layer 2 Fast Ethernet Switch
config 802.1x capability ports
Purpose Used to configure the 802.1x capability of a range of ports on the
Switch.
Syntax
config 802.1x capability ports [<portlist> | all] [authenticator |
none]
Description
The config 802.1x command has four capabilities that can be set for
each port. Authenticator, Supplicant, Authenticator and Supplicant,
and None.
Parameters
<portlist> − Specifies a port or range of ports to be configured.
all − Specifies all of the ports on the Switch.
authenticator − A user must pass the authentication process to gain
access to the network.
none − The port is not controlled by the 802.1x functions.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1x capability on ports 1-10:
DES-3526:4#config 802.1x capability ports 1 – 10 authenticator
Command: config 802.1x capability ports 1 – 10 authenticator
Success.
DES-3526:4#
config 802.1x auth_parameter
Purpose Used to configure the 802.1x Authentication parameters on a range
of ports. The default parameter will return all ports in the specified
range to their default 802.1x settings.
Syntax
config 802.1x auth_parameter ports [<portlist> | all] [default |
{direction [both | in] | port_control [force_unauth | auto |
force_auth] | quiet_period <sec 0-65535> | tx_period <sec 1-
65535> | supp_timeout <sec 1-65535> | server_timeout <sec 1-
65535> | max_req <value 1-10> | reauth_period <sec 1-65535> |
enable_reauth [enable | disable]}]
Description
The config 802.1x auth_parameter command is used to configure
the 802.1x Authentication parameters on a range of ports. The
default parameter will return all ports in the specified range to their
default 802.1x settings.
Parameters
<portlist> − Specifies a port or range of ports to be configured.
all − Specifies all of the ports on the Switch.
140
To Next Page
Loading...
