DES-3526 Layer 2 Fast Ethernet Switch
DES-3526:4#
config 802.1x auth_protocol
Purpose Used to configure the 802.1x authentication protocol on the Switch.
Syntax
config 802.1x auth_protocol [radius_eap | radius_pap]
Description The config 802.1x auth_protocol command enables you to configure
the authentication protocol.
Parameters radius_eap | radius_pap – Specify the type of authentication protocol
desired.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the authentication protocol on the Switch:
DES-3526:4# config 802.1x auth_protocol radius_pap
Command: config 802.1x auth_protocol local radius_pap
Success.
DES-3526:4#
config 802.1x init
Purpose Used to initialize the 802.1x function on a range of ports.
Syntax
config 802.1x init {port_based ports [<portlist> | all] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr>}]
Description
The config 802.1x init command is used to immediately initialize the
802.1x functions on a specified range of ports or for specified MAC
addresses operating from a specified range of ports.
Parameters port_based – This instructs the Switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization can
then be specified.
mac_based − This instructs the Switch to initialize 802.1x functions
based only on the MAC address. MAC addresses approved for
initialization can then be specified.
ports <portlist> − Specifies a port or range of ports to be configured.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> - Enter the MAC address to be initialized.
142
To Next Page
Loading...
