DES-3526 Layer 2 Fast Ethernet Switch
config 802.1x init
Restrictions Only administrator-level users can issue this command.
Example usage:
To initialize the authentication state machine of all ports:
DES-3526:4# config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DES-3526:4#
config 802.1x auth_mode
Purpose Used to configure the 802.1x authentication mode on the Switch.
Syntax
config 802.1x auth_mode {port_based | mac_based]
Description The config 802.1x authentication mode command is used to enable
either the port-based or MAC-based 802.1x authentication feature
on the Switch.
Parameters
[port_based | mac_based] − The Switch allows you to authenticate
802.1x by either port or MAC address.
Only administrator-level users can issue this command. Restrictions
Example usage:
To configure 802.1x authentication by MAC address:
DES-3526:4#config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
Success.
DES-3526:4#
config 802.1x reauth
Used to configure the 802.1x re-authentication feature of the Switch.
Syntax
config 802.1x reauth {port_based ports [<portlist> | all] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr>}]
Description The config 802.1x reauth command is used to re-authenticate a
previously authenticated device based on port number.
Purpose
143
To Next Page
Loading...
