D-Link DES-3526 - Page 39

DES-3526 Layer 2 Fast Ethernet Switch
Command Parameters
community
config snmp
engineID
<snmp_engineID>
show snmp
engineID
create snmp group <groupname 32> {v1 | v2c |v3 [noauth_nopriv | auth_nopriv |
auth_priv ]} {read_view <view_name 32> | write_view
<view_name 32> | notify_view <view_name 32>}
delete snmp group <groupname 32>
show snmp groups
create snmp host <ipaddr> {v1 |v2c | v3 [noauth_nopriv | auth_nopriv | auth_priv]}
<auth_string 32>
delete snmp host <ipaddr>
show snmp host <ipaddr>
create trusted_host <ipaddr>
delete trusted_host <ipaddr>
show trusted_host <ipaddr>
enable snmp traps
enable snmp
authenticate_traps
show snmp traps
disable snmp traps
disable snmp
authenticate_traps
config snmp system
contact
<sw_contact>
config snmp system
location
<sw_location>
config snmp system
name
<sw_name>
enable rmon
disable rmon
Each command is listed, in detail, in the following sections.
create snmp user
Purpose Used to create a new SNMP user and adds the user to an SNMP
group that is also created by this command.
Syntax
create snmp user <username 32> <groupname 32> {encrypted
[by_password auth [md5 <auth_password 8-16> | sha
<auth_password 8-20>] priv [none | des <priv_password 8-16>]
| by_key auth [md5 <auth_key 32-32> | sha <auth_key 40-40>]
priv [none | des <priv_key 32-32> ]]}
31