DES-3526 Layer 2 Fast Ethernet Switch
show firmware information
Parameters None.
Restrictions None
Example usage:
To display the current firmware information on the Switch:
DES-3526:4#show firmware information
Command: show firmware information
ID Version Size(B) Update Time From User
-- -------- ------- ------------------- ------------------ ---------------
1 2.00-B02 1360471 00000 days 00:00:00 Serial Port (PROM) Unknown
*2 1.00-B02 2052372 00000 days 00:00:56 10.53.13.94 Anonymous
'*' means boot up section
(T) means firmware update thru TELNET
(S) means firmware update thru SNMP
(W) means firmware update thru WEB
Free space: 3145728 bytes
DES-3526:4#
upload
Purpose Used to upload the current switch settings or the switch history log
to a TFTP.
Syntax
upload [ configuration | log ] <ipaddr> <path_filename 64>
Description This command is used to upload either the Switch’s current settings
or the Switch’s history log to a TFTP server.
Parameters
configuration − Specifies that the Switch’s current settings will be
uploaded to the TFTP server.
log − Specifies that the switch history log will be uploaded to the
TFTP server.
<ipaddr> − The IP address of the TFTP server. The TFTP server
must be on the same IP subnet as the Switch.
<path_filename 64> − Specifies the location of the Switch
configuration file on the TFTP server. This file will be replaced by
the uploaded file from the Switch.
Restrictions The TFTP server must be on the same IP subnet as the Switch.
Only administrator-level users can issue this command.
56
To Next Page
Loading...
