D-Link DES-3550 - Page 159

DES-3550 Layer 2 Fast Ethernet Switch
show link_aggregation
Purpose Used to display the current link aggregation configuration on the
Switch.
Syntax
show link_aggregation {group_id <value 1-6> | algorithm}
Description This command will display the current link aggregation
configuration of the Switch.
Parameters
<value 1-6> − Specifies the group ID. The Switch allows up to 6 link
aggregation groups to be configured. The group number identifies
each of the groups.
algorithm − Allows you to specify the display of link aggregation by
the algorithm in use by that group.
Restrictions None.
Example usage:
To display Link Aggregation configuration:
DES-3550:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID : 1
Master Port : 1
Member Port : 5-10
Active Port :
Status : Disabled
Flooding Port : 5
DES-3550:4#
155