D-Link DGS-1100-06/ME - Enable 802.1 X; Disable 802.1 X

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
174
Command
Parameter
show 802.1x user
delete 802.1x user
<username 15>
config 802.1x capability
ports
[<portlist> | all] [authenticator | none]
config 802.1x fwd_pdu
system
[enable | disable]
show 802.1x fwd_pdu
system status
Each command is listed in detail, as follows:
enable 802.1x
Purpose
To enable the 802.1x server on the Switch.
Syntax
enable 802.1x
Description
The enable 802.1x command enables the 802.1x Port-based
Network Access control server application on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To enable 802.1x switch wide:
DGS-1100-06/ME:5#enable 802.1x
Command: enable 802.1x
Success!
DGS-1100-06/ME:5#
disable 802.1x
Purpose
To disable the 802.1x server on the Switch.
Syntax
disable 802.1x
Description
The disable 802.1x command disables the 802.1x Port-based
Network Access control server application on the Switch.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To disable 802.1x on the Switch:
DGS-1100-06/ME:5#disable 802.1x
Command: disable 802.1x