D-Link DGS-1100-06/ME - Show Ipv6 Route; Enable Ipif_Ipv6_Link_Local_Auto System

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
205
DGS-1100-06/ME:5#delete ipv6route default
Command: delete ipv6route default
Success.
DGS-1100-06/ME:5#
show ipv6route
Purpose
Used to display IPv6 routes.
Syntax
show ipv6route
Description
This show ipv6route command displays the IPv6 routes.
Parameters
None.
Restrictions
None.
Example usage:
To show IPv6 route:
DGS-1100-06/ME:5# show ipv6route
Command: show ipv6route
IPv6 Prefix: ::/0 Protocol: Static Metric: 1
Next Hop : 2000::1 IPIF : System
Total Entries: 1
DGS-1100-06/ME:5#
enable ipif_ipv6_link_local_auto System
Purpose
Used to enable the autoconfiguration of the link local address when
no IPv6 address is configured.
Syntax
enable ipif_ipv6_link_local_auto System
Description
This enable ipif_ipv6_link_local_auto System command will
automatically create an IPv6 link local address for the Switch if no
IPv6 address has previously been configured.
Parameters
None.
Restrictions
Only Administrator or operator-level users can issue this command.
Example usage:
To enable the IP interface IPv6 link-local settings on the switch: