D-Link DGS-1100-06/ME - Lldp Commands

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
234
36
LLDP COMMANDS
The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
Parameter
enable lldp
disable lldp
config lldp
message_tx_interval
<sec 5-32768>
config lldp
message_tx_hold_multiplier
<int 2-10>
config lldp reinit_delay
<sec 1-10>
config lldp tx_delay
<sec 1-8192>
config lldp
notification_interval
<sec 5-3600>
show lldp
show lldp ports
{<portlist>}
show lldp local_ports
{<portlist>} {mode[brief | normal | detailed]}
show lldp remote_ports
{<portlist>} {mode[brief | normal | detailed]}
config lldp ports
[<portlist> | all] notification [enable | disable]
config lldp ports
[<portlist> | all] admin_status [tx_only | rx_only | tx_and_rx | disable]
config lldp ports
[<portlist>|all] mgt_addr [ipv4 <ipaddr>| ipv6 <ipv6addr>] [enable | disable]
config lldp ports
[<portlist>|all] basic_tlvs [all | {port_description | system_name |
system_description | system_capabilities}] [enable | disable]
config lldp ports
[<portlist>|all] dot3_tlvs [all | link aggregation | mac_phy_configuration_status
| maximum_frame_size] [enable | disable]
config lldp ports
[<portlist>|all] dot1_tlv_pvid [disable | enable]
config lldp ports
[<portlist>|all] dot1_tlv_protocol_identity [all | eapol | gvrp | lacp | stp][disable
| enable]
config lldp ports
[<portlist>|all] dot1_tlv_vlan_name [vlan <vlan_name 32> | vlanid <vidlist>]
[disable | enable]
show lldp mgt_addr
{ipv4 <ipaddr> | ipv6 <ipv6addr>}
show lldp statistics
{ports <portlist>}
Each command is listed in detail, as follows: