D-Link DGS-1100-06/ME - Upload

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
72
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!01–Jan–2000 01:22:49 %COPY–W–TRAP:
The copy operation was completed successfully
!
3920460 bytes copied in 00:03:01 [hh:mm:ss]
DGS-1100-06/ME:5#
To download a configuration file:
DGS-1100-06/ME:5#download configuration 10.48.74.121 c:\cfg\setting.txt
Overwrite file [startup-config] ?[Yes/press any key for no]....
01-Jan-200003:19:46%COPY-I-FILECPY:FilesCopy-source URL tftp://10.48.74.121/1.txt
destination
URL flash://startup-config
Success.
Success.
.....01-Jan-2000 03:18:40 %COPY-N-TRAP: The copy operation was completed
successfully!
Copy: 267 bytes copied in 00:00:08 [hh:mm:ss]
DGS-1100-06/ME:5#
upload
Purpose
To upload the current switch settings to a TFTP server.
Syntax
upload [[firmware [<ipaddr> | <ipv6_addr>] <path_filename 64>]
| [cfg_toTFTP [<ipaddr> | <ipv6_addr>] <path_filename 64>
config_id <value 1-2>] | [log_toTFTP [<ipaddr> | <ipv6_addr>]
<path_filename 64>]]
Description
The upload command uploads the Switch’s current settings to a
TFTP server.
Parameters
firmware − Specifies that the Switch’s current firmware are to be
uploaded to the TFTP server.
<ipaddr> − The IPv4 address of the TFTP server. The TFTP server
must be on the same IP subnet as the Switch.
<ipv6_addr> − The IPv6 address of the TFTP server. The TFTP
server must be on the same IP subnet as the Switch.
<path_filename 64> − The location of the Switch configuration file on
the TFTP server.
config_id <value 1-2> − Specifies the config id which to be
uploaded.