D-Link DGS-1100-06/ME - Network Monitoring Commands; Show Packet Ports

DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
83
13
NETWORK MONITORING COMMANDS
The Network Monitoring commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
Parameter
show packet ports
<portlist>
show error ports
<portlist>
show utilization
[ports {<portlist>} | cpu | mem]
clear counters
clear log
show log
{[index <value 1-500> - <value 1-500>] | module <string 32> | severity [debug |
informational | warning ]}
save log
enable syslog
disable syslog
show syslog
create syslog host
<index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity [informational | warning |
debug] | facility [local0 | local1| local2 | local3 | local4 | local5 | local6 | local7] |
state [enable | disable] | udp_port [514 | <udp_port_number 6000-65535>]}
config syslog host
[all | <index 1-4>] {severity [informational | warning | debug] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | state [enable | disable] |
udp_port [ 514 | <udp_port_number 6000-65535>] | ipaddress [<ipaddr> |
<ipv6addr>]}
delete syslog host
[<index 1-4> | all]
show syslog host
{<index 1-4>}
cable diagnostic port
[<portlist> | all]
Each command is listed in detail, as follows:
show packet ports
Purpose
To display statistics about the packets sent and received in frames
per second by the Switch.
Syntax
show packet ports <portlist>
Description
The show packet ports command displays statistics about packets
sent and received by ports specified in the port list. The results are
separated into three tables, labeled A, B, and C in the window
below. Table A is relevant to the size of the packets, Table B is
relevant to the type of packets and Table C is relevant to the type of