D-Link DGS-1100-06/ME - System > System Settings; System > DHCP Auto Configuration

4 SmartConsole Utility D-Link DGS-1100-06/ME User Manual
1
1
1
1
Figure 4.5 – SmartConsole Monitor List
Save: Records the setting of the Device List as default for the next time the SmartConsole Utility is used.
Save As: Records the setting of the Device List in an appointed filename and file path.
Restore: Manually reload a Device List setting file.
About
Click this icon to launch the SmartConsole Info window.
Figure 4.6 – SmartConsole About
Device Configuration
The Device Configuration in the SmartConsole Utility has five icons:
Device Settings
Password Settings
Firmware Upgrade
DHCP Refresh
Web Access
and the , , device buttons for the Device List.
Device Settings
Select a switch from the Device List. Click on this icon to launch the Device Settings window. Here you can
configure the Product Name, MAC Address, IPv4 Address, Subnet Mask, Gateway, System Name, Location,
Trap IP, Group Interval, and DHCP Client Setting of the Switch.
To apply the configuration, insert the correct device password in the Confirm Password box and then click
OK.