5 Configuration D-Link DGS-1100-06/ME User Manual
46
DHCPv6 Relay Hops Count Limit (1-32): The field allows and entry between 1 and 32 to define the
maximum number of router hops DHCPv6 messages can be forwarded. The default hop count is 4.
Interface: Enter a name of the interface.
Server IP: Enter the server IP address.
Click Apply to implement changes made.
Configuration > Ethernet OAM > Ethernet OAM Port Settings
Ethernet OAM (Operations, Administration, and Maintenance) is a data link layer protocol which provides
network administrators the ability to monitor the health of the network and quickly determine the location of
failing links or fault conditions on point-to-point and emulated point-to-point Ethernet link.
The Ethernet OAM Port Settings page allows user to configure the Ethernet OAM settings.
Figure 5.70 - Configuration > Ethernet OAM > Ethernet OAM Port Settings
From Port / To Port: Specified a range of ports to be configured.
Mode: Specify to operate in either active mode or passive mode. The default mode is active.
State: Specify to enable or disable the OAM function. The default state is disabled.
Remote Loopback: If start is specified, it will request the peer to change to the remote loopback mode. If
stop is specified, it will request the peer to change to the normal operation mode.
Received Remote Loopback: Specify whether to process or to ignore the received Ethernet OAM remote
loopback command. The default method is Ignore.
Click Apply to implement changes made.
Configuration > Ethernet OAM > Ethernet OAM Event Configuration
The Ethernet OAM Event Configuration page allows user to configure the Ethernet OAM Event settings.
Figure 5.71 - Configuration > Ethernet OAM > Ethernet OAM Event Configuration
To Next Page
Loading...
