5 Configuration D-Link DGS-1100-06/ME User Manual
62
To delete an Enable Method List defined by the use, click Delete button to the entry desired to be deleted.
To modify and Enable Method List, click Edit button to make the changes and click Apply.
Figure 5.99 – Security > Access Authentication control > Enable Method Lists
To define an Enable Login Method List, set the following parameter and click Apply:
Method List Name: Enter a method list name defined by the user of up to 15 characters.
Priority 1, 2, 3, 4: The user may add one, or a combination of up to four of the following authentication
methods to this method list:
none – Adding this parameter will require an authentication to access the Switch.
local – Adding this parameter will require the user to be authenticated using the local user account
database on the Switch.
radius – Adding this parameter will require the user to be authenticated using the RADIUS protocol
from a remote RADIUS server.
Security > Access Authentication Control > Local Enable Password Settings
The Local Enable Password Settings page allows user to configure the locally enabled password. When a
user chooses the "local_enable" method to promote user level privileges to administrator privileges, he or
she will be prompted to enter the password configured here that is locally set on the Switch.
Figure 5.100 – Security > Access Authentication control > Local Enable Password Settings
To set the Local Enable Password, set the following parameters and click Apply:
Old Local Enable Password: If a password was previously configured for this entry, enter it here in order to
change it to a new password.
New Local Enable Password: Enter the new password that you wish to set on the Switch to authenticate
users attempting to access Administrator Level privileges on the Switch. The user may set a password of up
to 15 characters.
Confirm Local Enable Password: Confirm the new password entered above. Entering a different password
here from the one set in the New Local Enabled field will result in a fail message.
Security > Traffic Segmentation
This feature provides administrators to limit traffic flow from a single port to a group of ports on a single
Switch. This method of segmenting the flow of traffic is similar to using VLANs to limit traffic, but is more
restrictive.
To Next Page
Loading...
