D-Link DGS-1100-06/ME - Monitoring > Cable Diagnostics; Monitoring > System Log

5 Configuration D-Link DGS-1100-06/ME User Manual
6
6
9
9
Figure 5.112 - Monitoring > Packets > Received (RX) (line graph for Bytes and Packets)
To view the Received Packets Table, click the link View Table, which will show the following table:
Figure 5.113 - Monitoring > Packet s > Received (RX) (table for Bytes and Packets)
The following fields can be set or viewed:
Time Interval: Select the desired setting between 1s and 60s, where “s” stands for seconds. The default
value is one second.
Record Number: Select number of times the Switch will be polled between 20 and 200. The default value is
200.
Bytes: Counts the number of bytes received on the port.
Packets: Counts the number of packets received on the port.
Unicast: Counts the total number of good packets that were received by a unicast address.
Multicast: Counts the total number of good packets that were received by a multicast address.
Broadcast: Counts the total number of good packets that were received by a broadcast address.
Show/Hide: Check whether or not to display Bytes and Packets.