5 Configuration D-Link DGS-1100-06/ME User Manual
72
Figure 5.117 - Monitoring > Errors > Transmitted (TX) (table)
The following fields can be set or viewed:
Time Interval: Select the desired setting between 1s and 60s, where “s” stands for seconds. The default
value is one second.
Record Number: Select number of times the Switch will be polled between 20 and 200. The default value is
200.
SingColl: Single Collision Frames. The number of successfully transmitted packets for which transmission is
inhibited by more than one collision.
MultiColl: Multi Collision Frames. The number of successfully transmitted packets for which transmission is
inhibited by multi collision.
DeferTrans: The number of frames for which the first transmission attempt was delayed because the
medium was busy.
LateColl: Counts the number of times that a collision is detected later than 512 bit-times into the
transmission of a packet.
ExColl: Excessive Collisions. The number of packets for which transmission failed due to excessive
collisions.
Show/Hide: Check whether or not to display SingColl, MultiColl, DeferTrans, LateColl and ExColl errors.
Clear: Clicking this button clears all statistics counters on this window.
View Table: Clicking this button instructs the Switch to display a table rather than a line graph.
View Line Chart: Clicking this button instructs the Switch to display a line graph rather than a table.
Monitoring > Errors > Received (RX)
This page displays the following graph of error packets received on the Switch. To select a port to view these
statistics for, select the port by using the Port pull-down menu. The user may also use the real-time graphic
of the Switch at the top of the web page by simply clicking on a port.
To Next Page
Loading...
