D-Link DGS-1100-10MP - SNMP and Logging Configuration

D-Link DGS-1100 MP/MPP Series Switch User Manual
44
The fields that can be configured for the SNMP Host Settings are described below:
Parameter Description
Host IPv4 Address
Enter the IP address of the SNMP Network Management
Server (NMS) which will receive SNMP Traps from this device.
Click the Apply button to accept the changes made.
The fields that can be configured for the Log Server are described below:
Parameter Description
Host IPv4 Address
Enter the IP address of the Syslog NMS which will receive
Syslog messages from this device.
Click the Apply button to accept the changes made.
The fields that can be configured for the Password Settings are described below:
Parameter Description
Password
Configure the password that will be used to restrict access to
the device via the Web UI. Password length is a maximum of
20 characters.
Confirm Password
Confirm the password that will be used to restrict access to the
device via the Web UI. Password length is a maximum of 20
characters.
Click the Apply button to accept the changes made.
The fields that can be configured for the Uplink Port Settings are described below:
Parameter Description
From Port Enter the start port in the range for Uplink Ports. These are
used for connecting the surveillance VLAN with other
switches.
To Port Enter the end port in the range for Uplink Ports. These are
used for connecting the surveillance VLAN with other
switches.
Click the Apply button to accept the changes made.
Click the Delete button to delete any entries in the list of uplink ports.