D-Link DGS-1210-08P - Page 149

6 Command Line Interface D-Link Smart Managed Switch User Manual
142
Command Parameter
enable ddpClient
enable nmsManaged
logout
ping <ip_addr>
ping6 <ipv6addr>
reboot
reset config
save [config config_id <integer (1-2)>]
show boot_file
show ddpClient
show firmware
information
show flash
information
show ipif [<ipif_name>]
show nmsManaged
show route {ipv4 | ipv6}
show switch
upload
{firmware_toTFTP {<ipaddr>| <ipv6addr>} <path_filename (64)>
image_id <integer 1-2> | cfg_toTFTP {<ipaddr>| <ipv6addr>}
<path_filename (64)> config_id<integer (1-2)>}
Each command is listed in detail, as follows:
?
Purpose To display a list of commands.
Syntax ?
Description The ? command displays a list of commands of the switch.
Parameters None.
Restrictions None.
Example usage:
To display a list of commands of the switch:
DGS-1210-24P> ?
USEREXEC commands :
config account admin password <passwd>
config configuration config_id <integer (1-2)> {delete | boot_up }
config firmware image_id <integer (1-2)> boot_up
config ipif <ipif_name> { ipaddress <ip-address> <subnet-mask> gateway <gw-add
ress> | dhcp | bootp }