6 Command Line Interface D-Link Smart Managed Switch User Manual
154
User : Anonymous (unknown)
DGS-1210-08P>
Purpose To display the configuration of an IP interface on the Switch.
Syntax show ipif [<ipif_name>]
Description The show ipif command displays the current IP address of the
switch.
Parameters <ipif_name> − Specifies the IP interface name to be displayed.
Restrictions None.
Example usage:
To display IP interface settings:
DGS-1210-52MP> show ipif
IP Setting Mode : Static
Interface Name : System
Interface VLAN Name : default
IP Address : 10.90.90.90
Subnet Mask : 255.0.0.0
Default Gateway : 0.0.0.0
DHCPv6 Client State : Disabled
DGS-1210-52MP>
Purpose To display the information of D-Link Nuclias Connect feature.
Syntax show nmsManaged
Description The show nmsManaged command displays the D-Link Nuclias
Connect status of the switch.
Parameters None.
Restrictions None.
Example usage:
To display the status of D-Link Nuclias Connect:
To Next Page
Loading...
