D-Link DGS-1210-10 - L2 Functions > LLDP > 802.1 Extension TLV

4 Configuration D-Link Web Smart Switch User Manual
5
5
3
3
Enabled – Enables LLDP notification on the port.
Disabled – Disables LLDP notification on the port. This is the default value.
Admin Status: Specifies the LLDP transmission mode on the port. The possible field values are:
TX_Only – Enables transmitting LLDP packets only.
RX_Only – Enables receiving LLDP packets only.
TX_and_RX – Enables transmitting and receiving LLDP packets. This is the default.
Disabled – Disables LLDP on the port.
Port Description: Specifies whether the Port Description TLV is enabled on the port. The possible field
values are:
Enabled – Enables the Port Description TLV on the port.
Disabled – Disables the Port Description TLV on the port.
System Name: Specifies whether the System Name TLV is enabled on the port. The possible field values
are:
Enabled – Enables the System Name TLV on the port.
Disabled – Disables the System Name TLV on the port.
System Description: Specifies whether the System Description TLV is enabled on the port. The possible
field values are:
Enabled – Enables the System Description TLV on the port.
Disabled – Disables the System Description TLV on the port.
System Capabilities: Specifies whether the System Capabilities TLV is enabled on the port. The possible
field values are:
Enabled – Enables the System Capabilities TLV on the port.
Disabled – Disables the System Capabilities TLV on the port.
Define these parameter fields. Click Apply to implement changes made and click Refresh to refresh the
table information.
L2 Functions > LLDP > 802.1 Extension TLV
This 802.1 Extension TLV page is used to configure the LLDP Port settings.
Figure 4.64 – L2 Functions > LLDP > 802.1 Extension TLV Port Settings
From Port / To Port : A consecutive group of ports may be configured starting with the selected port.
Port VLAN ID : Specifies the Port VLAN ID to be enabled or disabled.
VLAN Name : Specifies the VLAN name to be enabled or disabled in the LLDP port. If select Enabled, users
can specifies the content of VLAN ID or VLAN Name or all.
Protocol Identity : Specifies the Protocol Identity to be enabled or disabled in the LLDP port. If select
Enabled, users can specifies the EAPOL, LACP, GVRP, STP or ALL.
Click Apply to implement changes made and click Refresh to refresh the table information.