D-Link DGS-1210/ME series - Config Multicast_Filtering_Mode; Delete Auto_Fdb

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
190
Success.
DGS-1210-28MP/ME:5#
config multicast_filtering_mode
Purpose To configure the multicast packet filtering mode.
Syntax
config multicast_filtering_mode vlan <vlan_name 32>
[filter_unregistered_groups | forward_unregistered_groups]
Description
The config multicast filtering_mode command enables filtering or
forwarding of multicast addresses.
Parameters
<vlan_name 32> - Specifies the VLAN name.
[filter_unregistered_groups | forward_unregistered_groups] –
Specifies to fil
ter or forward the unregistered groups of multicast
address.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure the multicast packet filtering mode to forward all unregistered multicast groups:
DGS-1210-28MP/ME:5#
config multicast_filtering_mode vlan default
forward_unregistered_groups
Command: config multicast_filtering_mode vlan default
forward_unregistered_groups
Success.
DGS-1210-28MP/ME:5#
delete auto_fdb
Purpose To delete a static entry in the auto forwarding table (database).
Syntax
delete auto_fdb <ipaddr>
Description
The delete auto_fdb command removes
a static entry in the
multicast MAC address forwarding table (database).
Parameters
<ipaddr> − The IP address to be deleted from the auto forwarding
table.
Restrictions None.
Example usage:
To delete auto forwarding table:
DGS-1210-28MP/ME:5# delete auto_fdb 172.21.47.13
Command: delete auto_fdb 172.21.47.13
Success.
DGS-1210-28MP/ME:5#