D-Link DGS-1210/ME series - Limited Ip Multicast Address Commands; Create Mcast_Filter_Profile

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
360
46
LIMITED IP MULTICAST ADDRESS COMMANDS
The 802.1X commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command
Parameter
create
mcast_filter_profile
[ipv4 | ipv6] profile_id <integer 1-24> profile_name <string 20>
config
mcast_filter_profile
profile_id
<integer 1-24> [[add | delete] <mcast_addr> | profile_name <string 20>]
config
mcast_filter_profile
profile_name
<string 20> [[add | delete] <mcast_addr> | profile_name <string 20>]
config
mcast_filter_profile
ipv6
[profile_id <integer 1-24> | profile_name <string 20>] [add | delete]
<mcastv6_addr>
delete
mcast_filter_profile
[ipv4 | ipv6] [profile_id [all | <integer 1-24>] | profile_name <string 20>]
show
mcast_filter_profile
{[ipv4 | ipv6]} {profile_id <integer 1-24> | profile_name <string 20>}
config
limited_multicast_addr
ports <portlist> [ipv4 | ipv6] {[add | delete] [profile_id <integer 1-24> |
profile_name <string 20>] | access [permit | deny]}
show
limited_multicast_addr
ports <portlist> {[ipv4 | ipv6]}
config
max_mcast_group
ports <portlist> [ipv4 | ipv6] max_group <integer 1-1024> action [drop | replace]
show
max_mcast_group
ports <portlist> {[ipv4 | ipv6]}
Each command is listed in detail, as follows:
create mcast_filter_profile
Purpose To create multicast filtering profile on the Switch.
Syntax
create mcast_filter_profile [ipv4 | ipv6] profile_id <integer 1-24>
profile_name <string 20>
Description
The create mcast_filter_profile
command displays the multicast
filtering profiles settings.
Parameters
[ipv4 | ipv6] – Specify the IPv4 or IPv6 of multicast filter profile to be
created on the Switch.
profile_id <integer 1-24> -
Specify the profile id of multicast filter
profile on the Switch.
profile_name <string 20> - Specify the profile name of multicast filter