DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
100
messages sent from the device to the IGMP host or vice versa. The Switch monitors IGMP messages and
discontinues forwarding multicast packets when there are no longer hosts requesting that they continue.
To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping
Settings, as shown below:
Figure 5-44 IGMP Snooping Settings Window
The fields that can be configured in Global Settings are described below:
Parameter Description
Global State
Select to globally enable or disable IGMP snooping here. By default, this is
disabled.
Click the Apply button to accept the changes made.
The fields that can be configured in VLAN Status Settings are described below:
Parameter Description
VID
Enter the VLAN ID here. The range is from 1 to 4094. Select to enable or disable
IGMP snooping on the VLAN.
Click the Apply button to accept the changes made.
The fields that can be configured in IGMP Snooping Table are described below:
Parameter Description
VID
Enter the VLAN ID from 1 to 4094.
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to view all the entries.
Click the Show Detail button to see the detail information of the specific VLAN.
Click the Edit button to re-configure the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
To Next Page
Loading...
