DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
108
Parameter Description
Max Response Time Enter the maximum response time, in seconds, advertised in MLD snooping
queries. The range is from 1 to 25.
Robustness Value
Enter the robustness variable used in MLD snooping. The range is from 1 to 7.
Last Listener Query Interval
Enter the interval at which the MLD snooping querier sends MLD group-specific or
group-source-specific (channel) query messages. The range is from 1 to 25.
Click the Apply button to accept the changes made.
MLD Snooping Groups Settings
This window is used to display and configure the MLD snooping static group, and view MLD snooping group.
To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD Snooping Groups
Settings, as shown below:
Figure 5-53 MLD Snooping Groups Settings Window
The fields that can be configured in MLD Snooping Static Groups Settings are described below:
Parameter Description
VID
Enter the VLAN ID of the multicast group here. The range is from 1 to 4094.
Group Address
Enter the IPv6 multicast group address here.
From Port - To Port
Select the appropriate port range used for the configuration here.
VID
Click the radio button and enter a VLAN ID of the multicast group. The range is
from 1 to 4094.
Group Address
Click the radio button and enter an IPv6 multicast group address.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to view all the entries.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
To Next Page
Loading...
