DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
195
The fields that can be configured are described below:
Parameter Description
VID List
Enter the VLAN ID list used here.
Click the Clear by VLAN button to clear the information based on the VLAN ID(s) entered.
Click the Clear All button to clear all the information in this table.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
ARP Inspection Log
This window is used to view, configure, and clear the ARP inspection log information.
To view the following window, click Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP Inspection Log, as
shown below:
Figure 9-35 ARP Inspection Log Window
The fields that can be configured are described below:
Parameter Description
Log Buffer Enter the log buffer value used here. This value must be between 1 and 1024. By
default, this value is 32.
Click the Apply button to accept the changes made.
Click the Clear Log button to clear the log.
IP Source Guard
IP Source Guard Port Settings
This window is used to display and configure the IP Source Guard (IPSG) port settings.
To view the following window, click Security > IMPB > IPv4 > IP Source Guard > IP Source Guard Port Settings,
as shown below:
Figure 9-36 IP Source Guard Port Settings Window
To Next Page
Loading...
