D-Link DGS-1250 Series - DHCP Relay

DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
50
After clicking the Edit button, the following window will appear.
Figure 4-23 DHCP Class Settings (Edit) Window
The fields that can be configured are described below:
Parameter Description
Option
Enter the DHCP option number. The range is from 1 to 254.
Hex Enter the hex pattern of the specified DHCP option. Tick the * check box not to
match the remaining bits of the option.
Bitmask
Enter the hex bit mask for masking of the pattern. The masked pattern bits will be
matched. If not specified, all bits entered in the Hex field will be checked.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
Click the Back button to return to the previous window.
DHCP Relay
DHCP Relay Global Settings
This window is used to display and configure the global DHCP relay settings.
To view the following window, click Management > DHCP > DHCP Relay > DHCP Relay Global Settings, as shown
below:
Figure 4-24 DHCP Relay Global Settings Window
The fields that can be configured are described below:
Parameter Description
DHCP Smart Relay State
Select to globally enable or disable the DHCP smart relay state here.
Click the Apply button to accept the changes made.