D-Link DGS-1510/ME Series - Page 316

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
312
DGS-1510-28XMP/ME:admin# show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-Source-Dest
Group ID : 1
Type : LACP
Master Port : 5
Member Port : 5-7
Active Port :
Status : Enabled
Flooding Port :
Total Entries : 1
DGS-1510-28XMP/ME:admin#
Link aggregation group disabled:
DGS-1510-28XMP/ME:admin# show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-Source-Dest
Group ID : 1
Type : LACP
Master Port : 5
Member Port : 5-7
Active Port :
Status : Disabled
Flooding Port : 7
Total Entries : 1
DGS-1510-28XMP/ME:admin#
37-6 config lacp_port
Description
This command is used to configure per-port LACP mode.
Format
config lacp_port <portlist> mode [active | passive]
Parameters
<portlist> - Enter the list of ports used for the configuration here.
mode - Specifies the LACP mode used.
active - Specifies to set the LACP mode as active.
passive - Specifies to set the LACP mode as passive.