D-Link DGS-1510/ME Series - Page 327

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
323
DGS-1510-28XMP/ME:admin# show lldp
Command: show lldp
LLDP System Information
Chassis ID Subtype : MAC Address
Chassis ID : 00-01-02-03-04-00
System Name :
System Description : Fast Ethernet Switch
System Capabilities : Repeater, Bridge
LLDP Configurations
LLDP Status : Enabled
LLDP Forward Status : Enabled
Message TX Interval : 30
Message TX Hold Multiplier: 4
ReInit Delay : 2
TX Delay : 2
Notification Interval : 10
DGS-1510-28XMP/ME:admin#
38-8 show lldp mgt_addr
Description
This command is used to display the LLDP management address information.
Format
show lldp mgt_addr {[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
Parameters
ipv4 - (Optional) Specifies the IPv4 address used for the display.
<ipaddr> - Enter the IPv4 address used for this configuration here.
ipv6 - (Optional) Specifies the IPv6 address used for the display.
<ipv6addr> - Enter the IPv6 address used for this configuration here.
Restrictions
None.
Example
To display management address information: