DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
345
Restrictions
None.
Example
To show the LBD settings on ports 1-9:
DGS-1510-28XMP/ME:admin# show loopdetect ports 1-9
Command: show loopdetect ports 1-9
Port Loopdetect State Loop Status
------ ------------------ ----------
1 Enabled Normal
2 Enabled Normal
3 Enabled Normal
4 Enabled Normal
5 Enabled Loop!
6 Enabled Normal
7 Enabled Loop!
8 Enabled Normal
9 Enabled Normal
40-7 config loopdetect trap
Description
This command is used to configure the trap modes for LBD.
Format
config loopdetect trap [none | loop_detected | loop_cleared | both]
Parameters
none - Specifies that there is no trap in the LBD function.
loop_detected - Specifies that trap will only be sent when the loop condition is detected.
loop_cleared - Specifies that trap will only be sent when the loop condition is cleared.
both - Specifies that trap will either be sent when the loop condition is detected or cleared.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To specify that traps will be sent when the loop condition is detected or cleared:
To Next Page
Loading...
