D-Link DGS-1510/ME Series - Page 393

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
389
45-17 clear mld_snooping data_driven_group
Description
This command is used to delete the MLD snooping groups learned by data driven.
Format
clear mld_snooping data_driven_group [all | [vlan_name <vlan_name> | vlanid <vlanid_list>] [<ipv6addr>|
all]]
Parameters
all - Specifies all VLANs to which MLD snooping groups will be deleted.
vlan_name - Specifies the VLAN name.
<vlan_name> - Enter the VLAN name here.
vlanid - Specifies the VLAN ID.
<vlanid_list> - Enter the VLAN ID list here.
<ipv6addr> - Enter the group’s IP address learned by data driven.
all - Specifies to clear all data driven groups of the specified VLAN.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To clear all the groups learned by data-driven:
DGS-1510-28XMP/ME:admin# clear mld_snooping data_driven_group all
Command: clear mld_snooping data_driven_group all
Success.
DGS-1510-28XMP/ME:admin#
45-18 show mld_snooping statistic counter
Description
This command is used to display the statistics counter for MLD protocol packets that are received by the Switch
since MLD snooping was enabled.
Format
show mld_snooping statistic counter [vlan <vlan_name> | vlanid <vlanid_list> | ports <portlist>]
Parameters
vlan - Specifies a VLAN to be displayed.
<vlan_name> - Enter the VLAN name here.