D-Link DGS-1510/ME Series - Page 580

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
576
addresses.
<ipaddr> - (Optional) Enter the IP address used for the configuration here.
none - Specifies to clear the configured source IP interface.
Restrictions
Only Administrators and Operators can issue this command.
Example
Configure trap source IP interface:
DGS-1510-28XMP/ME:admin# config trap source_ipif System
Command: config trap source_ipif System
Success
DGS-1510-28XMP/ME:admin#
To clear the configured trap source IP interface:
DGS-1510-28XMP/ME:admin# config trap source_ipif none
Command: config trap source_ipif none
Success
DGS-1510-28XMP/ME:admin#
69-4 show trap source_ipif
Description
This command is used to display the trap source IP interface.
Format
show trap source_ipif
Parameters
None.
Restrictions
None.
Example
Show trap source IP interface: