D-Link DGS-1510/ME Series - Page 66

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
62
DGS-1510-28XMP/ME:admin# show authen application
Command: show authen application
Application Login Method List Enable Method List
----------- ----------------- ------------------
Console default default
Telnet login_list_1 default
SSH default default
HTTP default default
DGS-1510-28XMP/ME:admin#
5-16 create authen server_group
Description
This command is used to create a user-defined authentication server group. The maximum supported number of
server groups including built-in server groups is 8. Each group consists of 8 server hosts as maximum.
Format
create authen server_group <string 15>
Parameters
<string 15> - Enter the user-defined server group name. This value can be up to 15 characters long.
Restrictions
Only Administrators can issue this command.
Example
To create a user-defined authentication server group:
DGS-1510-28XMP/ME:admin# create authen server_group mix_1
Command: create authen server_group mix_1
Success.
DGS-1510-28XMP/ME:admin#
5-17 config authen server_group
Description
This command is used to add or remove an authentication server host to or from the specified server group. Built-
in TACACS, XTACACS, TACACS+, or RADIUS server group accepts the server host with the same protocol only,
but user-defined server group can accept server hosts with different protocols.