DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
107
Figure 5-30 MST Configuration Identification window
The fields that can be configured for MST Configuration Identification are described below:
Parameter Description
Configuration Name
Enter the MST This name uniquely identifies the MSTI (Multiple
Spanning Tree Instance). If a Configuration Name is not set, this field
will show the MAC address to the device running MSTP.
Revision Level
Enter the revision level value here. This value must be between 0 and
65535. By default, this value is 0. This value, along with the
Configuration Name, identifies the MSTP region configured on the
Switch.
Click the Apply button to accept the changes made.
The fields that can be configured for Instance ID Settings are described below:
Parameter Description
Instance ID
Enter the instance ID here. This value must be between 1 and 16.
Action
Select the action that will be taken here. Options to choose from are
Add VID and Remove VID.
VID List
Enter the VID list value here. This field is used to specify the VID range
from configured VLANs set on the Switch.
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
STP Instance
This window is used to view and configure the STP instance settings.
To view the following window, click L2 Features > Spanning Tree > STP Instance, as shown below:
To Next Page
Loading...
