DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
191
from are Any, Host, and IP. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host’s IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
IP Precedence
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network).
ToS
After selecting the IP precedence value, select the Type-of-Service
(ToS) value that will be used here. Options to choose from are 0
(normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (max-
throughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15.
DSCP
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Time Range
Enter the name of the time range to associate with this ACL rule.
Action
Select the action that this rule will take here. Options to choose from
are Permit and Deny.
Click the Back button to return to the previous window.
Click the Next button to continue.
After clicking the IPv6 radio button and the Next button, the following window will appear.
Figure 8-20 ACL Configuration Wizard (Add Rule for IPv6 ACL) window
This window has a dynamic section. Every selection made in the Protocol Type drop-down list will
change the bottom part of this window.
The fixed fields that can be configured are described below:
Parameter Description
Sequence No.
Enter the ACL rule number here. This value must be between 1 and
65535. Select Auto Assign to automatically generate an ACL rule
number for this entry.
Protocol Type Select the protocol type option here. Options to choose from are TCP,
To Next Page
Loading...
