DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
305
Static ACL Select whether to use a static ACL or not here by either selecting Yes
or No.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove an entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
ARP Inspection Port Settings
This window is used to view and configure the ARP inspection port settings.
To view the following window, click Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP
Inspection Port Settings, as shown below:
Figure 9-44 ARP Inspection Port Settings window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the appropriate port range used for the configuration here.
Rate Limit
Enter the rate limit value here. This value must be between 1 and 150
packets per seconds.
Burst Interval
Enter the burst interval value here. This value must be between 1 and
To Next Page
Loading...
