DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
307
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
ARP Inspection Log
This window is used to view, configure and clear the ARP inspection log information.
To view the following window, click Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP
Inspection Log, as shown below:
Figure 9-47 ARP Inspection Log window
The fields that can be configured are described below:
Parameter Description
Log Buffer
Enter the log’s buffer value used here. This value must be between 1
and 1024. By default, this value is 32.
Click the Apply button to accept the changes made.
Click the Clear Log button to clear the log.
IP Source Guard
IP Source Guard Port Settings
This window is used to view and configure the IP source guard port settings.
To view the following window, click Security > IMPB > IPv4 > IP Source Guard > IP Source Guard Port
Settings, as shown below:
Figure 9-48 IP Source Guard Port Settings window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the appropriate port range used for the configuration here.
State
Select to enable or disable the IP source guard’s state for the specified
To Next Page
Loading...
