DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
309
IP Address
Enter the IP address of the binding entry here.
MAC Address
Enter the MAC address of the binding entry here.
VID
Enter the VLAN ID of the binding entry here.
Type
Select the type of binding entry to find here. Options to choose from
are All, DHCP Snooping, and Static. Selecting All specifies that all
the DHCP binding entries will be displayed. Selecting DHCP
Snooping specifies to display the IP-source guard binding entry
learned by DHCP binding snooping. Selecting Static specifies to
display the IP-source guard binding entry that is manually configured.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete button to remove the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IP Source Guard HW Entry
This window is used to view the IP source guard hardware entries.
To view the following window, click Security > IMPB > IPv4 > IP Source Guard > IP Source Guard HW
Entry, as shown below:
Figure 9-50 IP Source Guard HW Entry window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this query here.
From Port / To Port
Select the appropriate port range used for the query here.
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Advanced Settings
IP-MAC-Port Binding Settings
This window is used to view and configure the IP-MAC-Port binding settings.
To view the following window, click Security > IMPB > IPv4 > Advanced Settings > IP-MAC-Port
Binding Settings, as shown below:
To Next Page
Loading...
